FEMEROL MTC200PRO Multi-Process Welder: up to 200 A, 220 V

What it welds

The FEMEROL MTC200PRO Multi-Process Welder is a multi-process with a maker-stated output of up to 200 amps on 220-volt input.

At its top output of 200 amps, Miller's 1-amp-per-thousandth rule points to about 0.200 in of steel per pass. Where the rule comes from.

The listing doesn't give a duty cycle with its amperage, which makes long beads hard to plan; the rating plate or manual should state it. Why it matters.

Processes, per the maker: mig, gas mig, plasma cutting, hf tig. Most multi-process machines' TIG is DC lift-arc, so no aluminium unless AC is stated. Choosing a process.

Plan a 240-volt circuit sized as the manual states before it arrives. What input voltage changes.

Use a lens of at least OSHA's minimum shade for the current: shade 10 or darker for typical MIG work here. Shade chart.

Also on the listing: a weight of 42 lb.

Is it the right machine for the job?

Buy it for

A shop that does a bit of everything
Steel to about 0.200 in per pass

Skip it for

Steel much past 0.200 in in one pass

What it does well, where it falls short

Does well

Up to 200 A output
Multi-process

Falls short

Duty cycle not stated with amps
Needs a 240 V circuit
Torches may be extra

Power and setup notes

Ratings are the maker's own, stated under the maker's conditions. Follow the manual, wear eye protection of at least OSHA's minimum shade, keep combustibles away, ventilate, and have a licensed electrician install new circuits.

Rated output and specs

Every figure below comes from the source shown in brackets. Where the maker doesn't state something, we say so instead of estimating.

Model number	MTC200PRO	Retailer
Product weight	42 lb	Retailer
Power	ac	Retailer
Output range	200a	Retailer
Input power	220v	Retailer
Processes	mig, gas mig, plasma cutting, hf tig	Retailer
Shielding gas	Gasless	Retailer