What it welds
The ESAB 700301083 MIG Welder is a MIG / gas with a maker-stated output of 30 to 190 amps on 230-volt input.
By Miller's rule of thumb of 1 amp per 0.001 inch of steel, 190 amps reaches about 3/16 in in a single pass. Amps by thickness.
The listing doesn't give a duty cycle with its amperage, which makes long beads hard to plan; the rating plate or manual should state it. Why it matters.
Processes, per the maker: Flux-Core/MIG. Most multi-process machines' TIG is DC lift-arc, so no aluminium unless AC is stated. Choosing a process.
It runs solid wire under shielding gas for the cleanest wire-feed welds; most machines like it also run flux-core wire outdoors.
Plan a 240-volt circuit sized as the manual states before it arrives. What input voltage changes.
Use a lens of at least OSHA's minimum shade for the current: shade 10 or darker for typical MIG work here. Shade chart.
Also on the listing: a weight of 52.7 lb.
Is it the right machine for the job?
Buy it for
- Clean steel welds indoors
- Steel to about 3/16 in per pass
Skip it for
- Steel much past 3/16 in in one pass
What it does well, where it falls short
Does well
- Up to 190 A output
Falls short
- Duty cycle not stated with amps
- Needs a 240 V circuit
Power and setup notes
- Ratings are the maker's own, stated under the maker's conditions. Follow the manual, wear eye protection of at least OSHA's minimum shade, keep combustibles away, ventilate, and have a licensed electrician install new circuits.
Rated output and specs
Every figure below comes from the source shown in brackets. Where the maker doesn't state something, we say so instead of estimating.
| Model number | 700301083 | Retailer |
|---|---|---|
| Product weight | 52.7 lb | Retailer |
| Output range | 30–190 Amp | Retailer |
| Input power | 230 v | Retailer |
| Processes | Flux-Core/MIG | Retailer |
Machines to put next to it
Other mig and flux-core welders in the same amp range
- Everlast CYCLONE 312i MIG Welder
- Miller 907839 MIG Welder
- Hobart 500574001 MIG Welder
- Miller 907321 MIG Welder
Every mig and flux-core welders on one spec sheet · All ESAB machines listed
Final verdict
Built for clean steel welds indoors.
Where to buy
Our links open this exact model's product page. Prices and stock change; check what's included before you order.
Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure